Step by step instructions for gluing inner corners
When completing, the principal problem can be uneven walls and the consequent springs on the background. It is also vital to take into account that when the walls are crooked, the joints of wallpaper canvases could invisibly.
After gluing the previous one in front of the inner corner of the cloth should measure the remaining distance. It’s measured from the edge of the glued cloth to the adjacent wall, so the resulting figure is inserted 10-15 millimeters. If the partitions are extremely curved, then the additional figure may be more.
Cut a strip equivalent to the resultant figure, taking into consideration the allowance. The surfaces have been treated with adhesive. Depending on the kind of coating it may be just the wall or the surfaces.
The strip is glued individually with the cut side to the wall. The background should go on the other airplane.
In case the glued wallpaper is wrinkled, you need to make several tiny cuts perpendicular to the springs.
Level or slope on the adjoining wall is a vertical line. The distance in the corner is equal to the diameter of the prior cut strip, never adding additions.
The surfaces have been smeared with adhesive, and then the coating is glued to the wall with the flat side into the marked line. The cut side goes on the adjoining wall.
Protruding corner ought to be pasted by analogy using an interior, but there are little gaps, which also need to be taken into account when working.
Measured the space remaining in the glued wallpaper to the adjacent wall. Add 20-25 millimeters to the captured figure.
A section is cut away, considering the additional 20-25 millimeters.
Before gluing, the surfaces gidpola.ru have been treated with glue.
The edge has to be glued into the background already fixed onto the wall, your own cut “goes” into the adjoining plane. If needed, small cuts are made in the area of going to the other wallpaper, smoothed and pushed to the wallsocket.
Draw a vertical strip on the adjacent wall in a distance of only glued cut strip plus 6-10 millimeters.
After applying the adhesive, the strip is then put on the wall using its flat side to the marked line, going over the edge of this already glued strip.
The joints are smeared with adhesive and ironed using a roller. Following that, the top layer is cut along the ruler and the 2 layers are combined together.
